EMIN is an Official GW Instek Distributor in Vietnam.

The global energy transition trend is driving industrial plants, chemical facilities, and renewable energy sites to integrate hydrogen as a strategic fuel source to achieve decarbonization goals. However, practical experience shows that traditional mechanical pressure gauges rapidly degrade in service life and experience dangerous failures when in direct contact with hydrogen environments.

In semiconductor cleanrooms, a single microscopic dust particle or a tiny toxic gas leak is enough to ruin an entire wafer batch worth millions of dollars. This vital requirement is accelerating a complete transition from traditional mechanical pressure gauges to digital pressure sensors and electronic pressure gauges.

The waste storage chamber in a high-rise building is an enclosed space where the continuous decomposition of organic matter generates ammonia (NH3) and hydrogen sulfide (H2S)—often accompanied by methane and various odor-causing compounds. These gases pose a direct health risk to sanitation staff, spread odors into the building's general ventilation system, and corrode electrical cabinets, piping, and technical equipment. This article addresses the questions frequently raised by building managers, M&E engineers, and occupational safety personnel

The Bosch GLM laser distance meter series has long been a staple on construction sites and in manufacturing workshops. Mastering these hidden features optimizes construction schedules and significantly reduces manual operational errors.

A 2-port probe can measure PCB power-rail impedance with minimal board changes. For the VDD_3V3_S0 example, ON-state impedance was checked against an approximately 8 mΩ target through 7 kHz.