Get exclusive volume discounts, bulk pricing updates, and new product alerts delivered directly to your inbox.
By subscribing, you agree to our Terms of Service and Privacy Policy.
Direct access to our certified experts
A pulse generator might look very powerful in a catalog, but when you actually test it in a real circuit, quite a few annoying issues start to emerge. Some models produce a beautiful sine wave but have slight ripple at the edges of the pulse; some require many steps to change the waveform; and some models develop a loss of smoothness in the rotary knob or noticeably slow menu response after only a few months of use
Sometimes, a pulse signal may appear perfectly normal at first glance, but when viewed on an oscilloscope, it reveals slight vibrations, uneven amplitude, or timing deviations in cycles. The first reaction is usually to check the pulse generator, connections, or output load. However, many errors originate from the power supply section, especially the switching power supply
In many drive systems, people often only pay attention to whether the machine is still running, whether there are any unusually loud noises, or whether the motor temperature has risen excessively. But there is a rather subtle parameter that directly affects the durability of the entire drive system: RPM, or the actual rotational speed of the deviceIn many drive systems, people often only pay attention to whether the machine is still running, whether there are any unusually loud noises, or whether the motor temperature has risen excessively. But there is a rather subtle parameter that directly affects the durability of the entire drive system: RPM, or the actual rotational speed of the device
In many mechanical workshops or QC departments, there's an interesting detail: the more surface measurement work is involved, the more granite surface plates are preferred over steel or aluminum. At first glance, this seems counterintuitive, as metal always feels much harder, stronger, and more "industrial" than stone
Increasing electricity costs month after month, even though the compressed air system is functioning normally, is a common situation faced by many factories. The compressor hasn't reported any errors, and the pressure is sufficient, so everything seems fine at first glance. Only during a thorough inspection do numerous leaks, long-standing and largely unnoticed, are discovered
