AMETEK CTS PA 5840-75 4-Quadrant Amplifier (100 / 120 / 230 VAC; 15 ... +60 Vpk, 0 ... 25 A, 150 kHz)

Output voltage (cont.): -15 ... 60 VDC ± 2%

Output current (cont.): 0 ... 25 A

Inrush current max.: 75 A for 200 ms

Bandwith (-3dB): DC ... 150kHz, full signal

Slew rate typical: < 10us (STD mode) / < 3us (HF mode)

Output range: +30 V / +60V

Source impedance: < 10 mΩ

Compensation Modes: CAP: DC ... 3kHz / STD: DC ... 40 kHz / HF: up to 150 kHz

Recovery time: 90 % of max. excursion within 25 µs

Sense Lines: Yes, voltage drop compensation in cabling, max. 4 VDC (AC up to to < 4 kHz)

Ripple voltage: ( noise) < 10 mV rms

Safety: Circuit breaker, over temperatur sensor, emergency stop (front panel)

Current limiter: 3x I max / 3x I control / peak off

DC Voltage limiter: Yes

Interfaces:

1 x ± 10 V analoge input voltage (BNC / D-Sub)

1 x ± 10 V analoge input current limiter (BNC / D-Sub)

Display: 2 x display 3.5 digit LED, red (voltage and current)

Cooling: Controlled air cooling

Power mains voltage: 120 V / 230 V ± 10 % L, N, PE

Fusage (circuit breaker): 12 A / 24 A **

Power mains frequency: 47 ... 63 Hz

Housing / Compartment: 19" rack

Dimension (L x W x H): 800 x 552 x 920 mm

Weight: 165 kg

Operating temperature: 10 ... 40 °C

Humidity: 10 ... 90%, non-condensing

Pressure: 860 mbar ... 1060 mbar

** Depending on mains voltage

Datasheet