EMIN completed training module "Proceq Metal Instrument Standardized Service" in Singapoore

Recently, EMIN has successfully completed the TRAINING MODULE "Proceq Metal Instrument Standardized Service" and is now authorized to carry out repairs, r

Recently, EMIN has successfully completed the TRAINING MODULE
"Proceq Metal Instrument Standardized Service"
and is now authorized to carry out repairs, replacements, upgrades and calibration of Proceq Concrete Instrument
Place: Proceq Asia Pte Ltd, Singapore
Date: 10th 11th May, 2018

The training modules covered the following specific topics:
• Functionality and operation of instrument
• Failure analysis of instrument and components
• Repairs of instrument and components
• Calibration of instrument and components
• Software Upgrade of instrument
The instruments covered were the Universal Platform, Equotip3 & Equotip Piccolo / Bambino.

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.