Techmart Hanoi 2013 exhibition, which was held from Sep 26, 2103 to Sep29, 2013 at Ha Noi Running Stage with 250 members and more than 300 booths, focused on these fields: automation, testing and measuring, information technology, electric, telecommunication, education, banking, software manufacture, medicine, new technology…

EMIN participated in Techmart Hanoi 2013 Exhibition

Techmart Hanoi 2013 exhibition, which was held from Sep 26, 2103 to Sep29, 2013 at Ha Noi Running Stage with 250 members and more than 300 booths, focused on these fields: Automation, testing and measuring, information technology, electric, telecommunication, education, banking, software manufacture, medicine, new technology…

Techmart Ha Noi 2013 has target to connect science examine, technology development with manufacture, business; support to change technology; promote competitive capacity; advance labour productivity and products quality with low cost; highten science-technology place of birth; growth change technology, activate connect to business international affiliation and resistant development.

EMIN Viet Nam participated in Techmart Ha Noi 2013 at booths 172, 173 with carefully preparation, investment at design and displaying, which has truly attention of visitor.

Following some images of EMIN booths at Techmart Ha Noi 2013 Exhibition.

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.