EMIN participated in the VINAMAC EXPO 2017

**Supported by the Ministry of Industry and Trade, Ministry of Planning and Investment; Ministry of Science and Technology, Vietnam Chamber of Commerce and In

Supported by the Ministry of Industry and Trade, Ministry of Planning and Investment; Ministry of Science and Technology, Vietnam Chamber of Commerce and Industry (VCCI), People's Committee of Ho Chi Minh City. Ho Chi Minh City, Ministries concerned; Vietnam Engineering Enterprise Association (VAMI) cooperated with Vietnam Exhibition and Advertisement Fair (VIETFAIR) to hold an international exhibition on machinery, equipment, materials and industrial products. Nam 12th (VINAMAC EXPO 2017) and topics: Machinery and Equipment (IMF - CMF); Five-piece industry and fixed components (CHF).

Here are some images of EMIN booth at the exhibition.

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.