EMIN tham gia hội chợ quốc tế hàng công nghiệp Việt Nam VIIF 2018

As an annual event, in 2018, EMIN Vietnam continued to participate in the trade fair to help businesses visually access measurement solutions. At the same tim

As an annual event, in 2018, EMIN Vietnam continued to participate in the trade fair to help businesses visually access measurement solutions. At the same time, it promoted EMIN's image to a wide range of manufacturers as a reputation supplier of measurement equipment, laboratory equipment, and automation solutions in Vietnam.

The VIETNAM INTERNATIONAL INDUSTRIAL FAIR 2018 has been held annually since 1991 with the aim of promoting investment and trade in the industrial sector between domestic businesses; and between Vietnamese businesses and international businesses. This year's VIIF 2018 brought together more than 250 domestic and international businesses participating with over 350 booths operating in the following fields:

1. Industrial Machinery and Equipment.

2. Machine Tools

3. Tools and Mechanical Equipment

4. Sheet Metalworking

5. Automation

6. Electric Equipment

7. Supporting Industry

....... and other industrial sectors.

Time: October 23-26, 2018

Location: ICE Hanoi International Exhibition Center - 91 Tran Hung Dao, Hanoi

During the 4-day fair, EMIN was delighted to welcome a large number of visitors.

At this VIIF fair, EMIN presented solutions for electrical, electronic, environmental, mechanical measurement, and many other fields from renowned global brands. We were honored to have Mr. Bala, representative of Datataker, participate and provide direct guidance.

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.