EXHIBITION INVITATION: EMA 2019 IN HCMC

EMIN Vietnam would like to invite customers & partners to visit our exhibition booth "Vietnam International Electricity, Industrial - Machinery & Automation 2019 - EMA 2019"

📍EMIN Vietnam booth position: 09-20, Zone B

🏡Venue: Center for Cultural Sport in Tan Binh District. Add: 448 Hoang Van Thu Str., Ward 4, Tan Binh District, HCMC, Vietnam

⏱Time: 09:00 am - 06:00 pm, 4 days 18~21/09/2019

EMA VIET NAM 2019 is organized with the aim of creating conditions for domestic and foreign exhibitors to introduce new products, equipment and technologies. Besides, it is also an opportunity for exhibitors to seek cooperation opportunities, attract investment, transfer of technology, promote trade promotion, bring more efficiency for production and business activities, contribute positively to the socio-economic development of our country.

At this exhibition, EMIN will bring electrical and electronic measuring and testing equipment, and introduce to customers measurement solutions in the fields of mechanics, manufacturing, environment meter equipment, laboratory equipment & automation equipment, etc. Gives customer a close look about the quality of EMIN products and services.

THANK YOU AND HOPE TO SEE YOU!

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.