LIVE WEBINAR: INSIGHTS INTO WIDE BAND-GAP APPLICATIONS AND MEASUREMENTS PART II

EMIN Viet Nam would like to invite you to join the webinar: "Insights into WIde Band-gap Applications and Measuremants Part II". The event is oganized by Tekt

EMIN Viet Nam would like to invite you to join the webinar: "Insights into WIde Band-gap Applications and Measuremants Part II". The event is oganized by Tektronix.

Date: 17 - Nov - 2021
Time: 11.00AM (GMT+8)

In this session, the presenter Carl Wong - Regional Application Engineer - will talk about the wide bandgap test challenges, measurement techniques, and test equipment needs including the requirements for a scope, probing techniques, and automated test software that can help meet the tough challenges presented by wide bandgap semiconductor devices.

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.