Unlock your scope's potential, all without leaving your lab!

If you own a Tektronix 4/5/6 Series Oscilloscope, you can receive 50% off on a license to upgrade bandwidth and record length, add a function generator, purchase individual or bundled software...

EMIN - Authorized Distributor of Tektronix is excited to announce a great way to extend the capabilities of your oscilloscopes. If you own a Tektronix 4/5/6 Series Oscilloscope, you can receive 50% off on a license to upgrade bandwidth and record length, add a function generator, purchase individual or bundled software. Unlock your scope's potential, all without leaving your lab!

Here are a few ways you can enhance your scope's performance:

• Increase bandwidth to achieve reliable measurement results at higher frequencies

• Extend record length to see more of the measured signal

• Add an integrated arbitrary function generator as a powerful tool for simulating signals or adding noise to existing signals

• Add Spectrum View for correlating time and frequency domains

• Automate advanced power measurements with POWER PRO software bundle

• Troubleshoot high-speed clock measurements with SERIAL DECODE PRO software bundle

Many options available as an exclusive offer for Tek scope owners. Don't wait - contact EMIN today! Offer ends June 27th.

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.