Webinar: Power Supply & E-Load Fundamentals, and Safety Testing Solution

EMIN Viet Nam would like to invite you to join the webinar Topic: Power Supply & E-Load Fundamentals, and Safety Testing Solution

EMIN Viet Nam would like to invite you to join the webinar Topic: Power Supply & E-Load Fundamentals, and Safety Testing Solution. The event is cooganized by GWinstek and EMIN.

Time: 10:00~12:15 VN time

Date: 26/06/2021 (Saturday)

Agenda:

10:00 ~ 10:45 Power supply introduction

10:45 ~ 11:30 E-load introduction

11:30 ~ 12:15 Safety tester introduction

At the seminar, you will have a better understanding of the basic knowledge in electronic measurement and have opportunity to ask questions directly with foreign experts from GWinstek. The participant is limited, register today to join us!

Related News

10/14/2026 16:09:27

DaiHan HP-20D & HP-30D Digital Laboratory Hotplates: Which Model Best Suits Your Needs?

Solution for standardized experimental temperature control, featuring a premium chemical-resistant, ceramic-coated aluminum top plate from DaiHan Scientific (South Korea)

10/14/2026 15:34:36

Controlling Water Quality Parameters to Meet EU and US Seafood Export Standards

Strictly controlling water environment parameters—from farming to preliminary processing—is not only a technical requirement to overcome technical barriers to trade (TBT) and sanitary and phytosanitary (SPS) measures, but also the key to protecting corporate reputation.

10/14/2026 11:27:30

Formula for Converting TOC to COD for Wastewater

This article addresses various questions in turn, covering whether conversion is permitted, how to establish the K-factor, when the factor ceases to be valid, and which equipment is suitable

10/14/2026 09:48:41

How Do You Measure Regulator Output Impedance and Load Steps?

Output impedance testing connects a J2111A current injector and probe to an LM117 output; small-signal load steps use an AWG and no injector bias current.

10/14/2026 09:47:49

How Does 2-Port Shunt-Through Impedance Measurement Work?

A 2-port shunt-through setup with the Bode 100 uses Gain/Phase mode, a 50 Ohm termination on Ch2, Thru calibration, and a logarithmic sweep to read impedance and estimate inductance.